SCANTECH ID (Champtek company) SG20 - Manual (Page 15)

Interface Manual Scantech SG-20 Discovery WLAN Rel 1.1 13
8 How to connect to a Discovery WLAN?
The Discovery WLAN can be configured in 3 ways (see Chapter 2 how to configure) :
- As a TCP Client
- As a TCP Server
- UDP
ATTENTION
On the back side of the Discovery, a wired Ethernet connection can be found. You can always
connect an Ethernet cable to this port for a guaranteed connection.
Connect to a Discovery TCP Client
You need a server program running on your computer. The IP address and port number of this
system should be correctly entered in the menus described in chapter 5.
If everything matches, the Discovery WLAN should automatically connect to this system.
On the distributed CD there are multiple examples on how to make a server program .
Connect to Discovery TCP Server
You need a client program (like U-Start, which can be found on the distributed CD) to connect to
the Discovery. You have to know the IP address and port number of the Discovery WLAN to
successfully connect to it. You could also use the MAC address of the Discovery and give it a
temporary IP address (like described in chapters 2 and 7). Instead of port 9999 (like in these
chapters) you use the port number you have assigned to this Discovery (see Chapter 5.5).
9 Related Documents
Discovery User’s Manual Scantech P/N A362001 Version 2.2
Discovery Product Support CD-ROM P/N A362103 Version 2.2
Lantronix WiPort User Guide Revision A 3.04
http://www.lantronix.com/support/ (Reference: WiPort)