SCANTECH ID (Champtek company) SG20 - Manual (Page 12)

Interface Manual Scantech SG-20 Discovery WLAN Rel 1.1 10
4 Configure the IP-Settings
Note: The most frequently used parameters of this menu can also be accessed through the
Discovery Service Menus (using the buttons) See Chapter 1
4.1 From the main menu, select a 0 to configure the IP address of the WLAN module.
4.2 First, select the required interface:
Network Mode (0=Wired Only 1=Wireless Only 2=Bridging(One Host) [0] ?
4.3 Input the required fixed SG-20 terminal IP address,
format: a xxx xxx xxx xxx a
In case 0 0 1 0 (= default setting) is entered,
you select the DHCP feature.
4.4 Set Gateway IP Address (N) a a
4.5 Netmask: No. of Bits for Host Part (0=default) (08)
a a
4.6 Change Telnet config password (N)
a a
4.7 Change DHCP Device Name(N)
a a
This options makes it possible to knock on the door of the DHCP Server,
using a unique name.