GE Industrial Solutions ASTAT-SD Solid-State Reduced Voltage Starter - Manual (Page 6)

ASTAT-SD ™ Solid-State Reduced Voltage Starters
Chapter 1. Technical Specifications
2
1-3 Technical Characteristics
Environmental
Temperature 0 to 45°C 1
Storage temperature -20 to +70°C
Relative humidity 95% without condensation
Maximum altitude 3300 feet (1000m) 2
Mounting positions Vertical
Electrical characteristics
Three phase supply voltage 500VAC +10% maximum
Frequency 48-62 Hz
Rated current 6 ratings, 5-34A
Motor horsepower (KW) 3-25hp at 460V (3-20 KW at 500V)
Motor voltages 200V, 230V, 460V (220V, 380/415V, 440V, 500V for IEC)
Control voltages 110/120VAC or 220/240VAC, 50/60Hz
Control characteristics
Control system Digital system with microcontroller
Starting ramp with progressive increase in voltage and
current limitation
Loss of control voltage 3 cycle ridethru
Starting
Initial (starting) torque
15 to 80% full voltage starting torque
Kick start 90% line voltage (80% full voltage starting torque), 400ms
Current limit 200 to 500% starter current
Acceleration ramp time .5 to 60 sec. 3
Running
Energy savings
Output voltage reduction based on power factor of running
motor to optimize system energy consumption
Override - energy savings Energy saving mode turned OFF
Stopping
Coasting
With no soft stop, power removed from motor
Stop time by ramp Soft stop time fixed at 2 x t
ramp
Inputs/Outputs
Starter control Start/Stop or remote contact
Inputs 2 isolated inputs for Start/Stop
Input ratings 12VDC supplied by ASTAT to solid state optoisolators
Output auxiliary relays Run/End of Ramp (at speed), DIP switch selectable