GE Industrial Solutions A-Series II Panelboards SE_TED - Manual (Page 4)

DEH40153
DEH40153 Rev.No.02 4
Figure 3. Attaching the shield insert to the shield for SE/TED breaker installation in A-
Series
®
II Panelboards.
12. If SE/TED breaker has to be installed after SG or SF/TFJ or FB as shown in
Figure 4 then gap between the breakers (dim A) has to be followed as mentioned
in Table 2. Replace the subsequent blank filler of dead front with SE/TED filler
plate given in kit ASPP6SE6D using steps 9 to 11.
13. If SE/TED breaker has to installed immediate after crossbar as shown in Figure 5
then gap between the breaker and crossbar has to be 0.0575inch.