GE Industrial Solutions ZBTE Series - Manual (Page 9)

Zenith ZTE/ZBTE Series Operation & Maintenance Manual Page 7 91 R -1000
Figure 5
Example of Field Connection Diagram
Notes: 1. See Field connection wiring diagram for additional wiring details.
2. Controller inputs and outputs are field reconfigurable. “Factory Settings: indicate configuration at time of shipment.
3. From MX350 Display, go to \HOME\INPUTS or \HOME\OUTPUTS to see current configuration.
4. Record user configuration in “Field Setting” area below.
Name Term # Description
TB Strip 15 Connected to Source 1 (NO)
14 Connected to Source 1 (Common)
13 Connected to Source 1 (NO)
12 Connected to Source 1 (Common)
11 Connected to Source 2 (NO)
10 Connected to Source 2 (Common)
9 Connected to Source 2 (NO)
8 Connected to Source 2 (Common)
7
6
5
4
3 Engine Start – NC
2 Engine Start – Common
1 Engine Start – NO
G Input
Strip
G 7 Disconnect Switch (DS)
Factory Use
Only
G 8 Test with Load (Q2)
Factory Use
Only
G 9 Load Shed from S2 (R15)
Factory Use
Only
G 10 Bypass Xfer Time Delay to S1
G 11 Inhibit Xfer to S2 (Q3)
G 12 Inhibit Xfer to S1 (Q7)
G 13 Engine Start (SW1)
Com +24VDC
Factory Use
Only
Name Term # Factory Setting Field Setting
G Output
Strip G 1 (NO/NC/
Common)
Load Shed from S2 (R15)
Factory Use
Only
G 2 (NO/NC/
Common)
Alternative Source Fail to Start
G 3 (NO/NC/
Common)
S1 Failure
G 4 (NO/NC/
Common)
S2 Failure to Connect
G 5 (NO/NC/
Common)
Load Control 1
Name Term # Description
TB Strip 12 Connected to Source 1 (NO)
11 Connected to Source 1 (Common)
10 Connected to Source 1 (NO)
9 Connected to Source 1 (Common)
8 Connected to Source 2 (NO)
7 Connected to Source 2 (Common)
6 Connected to Source 2 (NO)
5 Connected to Source 2 (Common)
4 Bypass in Source 1 (NO)
3 Bypass in Source 1 (Common)
2 Bypass in Source 2 (NO)
1 Bypass in Source 2 (Common)
3 Engine Start – NC
2 Engine Start – Common
1 Engine Start – NO
Non-Bypass ATS Bypass ATS