GE Industrial Solutions IT Series 600-2000VA - Manual (Page 5)

Modifications Reserved 1
OPM_ITS_USM_M06_M20_0US_V011 (09/2007)
1 - Important safety Instructions
1.1 Save these instructions
This manual contains important instructions that should be followed during installation and maintenance of the UPS. It also gives all necessary
information about the correct use of the UPS. Before attempting to install and start up the UPS, carefully read this manual. Keep this manual
next to the unit for future reference.
Full understanding of and compliance with the safety instructions and warnings contained in this manual are
CONDITIONS
to avoid any dangerous situation during installation, operation and maintenance work, and to preserve the maximum reliability of the
UPS system.
GE refuses any responsibility in case of non-observance, unauthorized alterations or improper use of the delivered UPS. The instructions in
this manual pertain to IT Series UPS models. Check your model number by looking at the rear panel of your UPS.
While every care has been taken to ensure the completeness and accuracy of this manual, GE accepts no responsibility or liability for any loss
or damage resulting from the use of the information contained in this document. Due to technical improvements, some of the information
contained in this manual may be changed without notice.
This document shall not be copied nor reproduced without the permission of GE.
1.2 Safety rules
CAUTION! RISK OF ELECTRIC SHOCK.
The UPS contains batteries. The load outlets may be electrically live, even when the UPS is disconnected from the utility.
The UPS contains potentially hazardous voltages. Do not open the unit; there are no user serviceable parts inside.
All maintenance and service work, except replacement of the batteries, should be performed by qualified service personnel.
After switching UPS unit OFF, wait two (2) minutes for the DC capacitors to discharge. Lethally high voltage may remain
at the terminals of the electrolytic capacitors.
Be aware that the inverter can restart automatically after the input voltage is restored.
CAUTION
There may be damage to the equipment if procedures and practices are not strictly observed and followed.
NOTE
Do not attempt to service the UPS unless you have had proper training. Refer all maintenance and servicing to properly
qualified, skilled and competent service personnel.
CAUTION
(Non-isolated Battery supply)
Risk of electric shock, battery circuit is not isolated from AC input; hazardous voltage may exist between battery terminals
and ground. Test before servicing. Remove watches, rings or other metal objects. Use insulated tools.
WARNING
Intend for installation in a controlled environment.
CAUTION
Do not dispose of batteries in a fire, they may explode.
Do not open or mutilate the battery, released electrolyte is harmful to the skin and eyes.
CAUTION
To reduce the risk of fire, connect only to a circuit provided with 20 amperes maximum branch circuit overcurrent
protection in accordance with the National Electric Code, ANSI/NFPA.
Qualified, skilled personnel are persons who (because of their training, experience, and position as well as their knowledge of appropriate
standards, regulations, health and safety requirements and working conditions) are authorized to be responsible for the safety of the
equipment, at all times while carrying out their normal duties and are therefore aware of, and can report, possible hazards.