GE Industrial Solutions ADVANCED SNMP WEB INTERFACE CARD - Manual (Page 5)

Modifications reserved Page 5/33
OPM_CNT_ADV_SNM_CRD_XGB_V050.doc Operating Manual ADVANCED SNMP / WEB INTERFACE CARD
3 SPECIFICATION
Here follows a short description regarding the different plugs present on the frontal panel of the card:
RS232 Port
Used only to
configure the
parameters of the
card (9600-N-8-1).
(see chapter 6).
Reset Button
For a complete
reset of the card.
Red Led
Indicates the
transmission and
reception of the
packets over the
LAN bus.
RJ45 Connector
Used to
communicate with
10 or 100 Mbits
according to the
standard 10Base - T
or 100Base –TX.
Green Led
Indicate 4 different operating modes of the card:
1. When on and stable, it indicates that the card is
powered, but there is no communication with the UPS.
2. When blinking slow (1/sec.), it indicates that the card is
powered and there is communication with the UPS.
3. When blinking fast (6/sec.), it indicates the card is
updating the ROM and in this case, it is most important
not to reset or disconnect the card.
4. If the card is started in the restore mode, the led is
blinking corresponding to the SOS notification (...---...).