GC EUROPE G-aenial - Manual (Page 27)

27 G-ænial Anterior & Posterior Technical Manual
9.0 instruction for use
liGht-cuReD cOmPOSite ReStORatiVe
For use only by a dental professional in the recommended indications.
RECOMMENDED INDICATIONS
a. G-ænial anteRiOR
1. Direct restorative for class iii, iV, V cavities.
2. Direct restorative for wedge-shaped defects and root surface cavities.
3. Direct restorative for veneers and diastema closure.
B. G-ænial POSteRiOR
1. Direct restorative for class i and ii cavities.
CONTRAINDICATIONS
1. Pulp capping.
2. in rare cases the product may cause sensitivity in some people. if any such reactions are
experienced, discontinue the use of the product and refer to a physician.
DIRECTIONS FOR USE
1. Shade Selection
clean the tooth with pumice and water. Shade selection should be made prior to isolation. Select
the appropriate G-ænial shades by referring to the G-ænial shade guide.
2. Cavity Preparation
Prepare cavity using standard techniques. Dry by gently blowing with oil free air.
note : For pulp capping, use calcium hydroxide.
3. Bonding Treatment
For bonding G-ænial to enamel and / or dentin, use a light-cured bonding system
such as Gc G-BOnD™, Gc Fuji BOnD lc or Gc uniFil® Bond (Fig. 1). Follow
manufacturer’s instructions.
4. Placement of G-ænial
1. Dispensing from a unitip
insert the G-ænial unitip into the unitip aPPlieR or equivalent. Remove the cap
and extrude material directly into the prepared cavity. use steady pressure (Fig .
2). maintain pressure on the applier handle while removing the unitip aPPlieR and unitip from the
mouth. this prevents the unitip from coming loose from the applier.
2 Dispensing from a syringe
Remove syringe cap and dispense material onto a mixing pad. Place the material into the cavity
using a suitable placement instrument. after dispensing, screw syringe plunger anticlockwise by a
half to full turn to release residual pressure inside the syringe. Replace cap immediately after use.
note :
1. Basically, material can be applied in a single layer to achieve aesthetic restorations using
Standard shades. For details, refer to the clinical hints.
2. material may be hard to extrude immediately after removing from cold storage. Prior to use,
leave to stand for a few minutes at normal room temperature.
3. after dispensing, avoid too long exposure to ambient light. ambient light can shorten the
manipulation time.
Fig. 1
Fig. 2