Asus T4-P5945GCX - Manual (Page 44)

4-4 Chapter 4: Motherboard Info
2. USB device wake-up (3-pin USBPW12, USBPW34)
Set these jumpers to +5V to wake up the computer from S1 sleep mode
(CPU stopped, DRAM refreshed, system running in low power mode) using
the connected USB devices. Set to +5VSB to wake up from S3 and S4 sleep
modes (no power to CPU, DRAM in slow refresh, power supply in reduced
power mode).
• The USB device wake-up feature requires a power supply that can provide
500mA on the +5VSB lead for each USB port. Otherwise, the system would
not power up.
• The total current consumed must NOT exceed the power supply capability
(+5VSB) whether under normal condition or in sleep mode.
3. Keyboard power (3-pin KBPWR)
This jumper allows you to enable or disable the keyboard wake-up feature.
Set this jumper to pins 2-3 (+5VSB) to wake up the computer when you press
a key on the keyboard (the default is the Space Bar). This feature requires
an ATX power supply that can supply at least 1A on the +5VSB lead, and a
corresponding setting in the BIOS.
R
P5L13L-X USB device Wake up
3 2 2 1
+5V
(Default)
+5VSB
USBPW34
3
2 2
1
+5V
(Default)
+5VSB
USBPW12
P5L13L-X
R
P5L13L-X
P5L13L-X Keyboard Power Setting
(Default)
+5V +5VSB
KBPWR
2 3 1 2