Asus T4-P5945GCX - Manual (Page 46)

4-6 Chapter 4: Motherboard Info
2. ATX power connectors (24-pin EATXPWR, 4-pin ATX12V)
These connectors are for the 24-pin and 4-pin power plugs from the power
supply unit. The plugs from the power supply unit are designed to fit these
connectors in only one orientation. Find the proper orientation and push down
firmly until the connectors completely fit.
Do not forget to connect the 4-pin ATX12V power plug to the ATX12V connector
on the motherboard. Otherwise, the system will not boot up.
R
P5L13L-X ATX Power Connector
EATXPWR
+3 V
olt
s
+3 V
olt
s
Ground +5 V
olt
s
+5 V
olt
s
Ground Ground Power OK +5V Standby +12 V
olt
s
-5 V
olt
s
+5 V
olt
s
+3 V
olt
s
-12 V
olt
s
Ground Ground Ground PSON# Ground
+5 V
olt
s
+12 V
olt
s
+3 V
olt
s
+5 V
olt
s
Ground
ATX12V
GN
D
+12V DC
GN
D
+12V DC
P5L13L-X
3. IDE connector (40-1 pin PRI_IDE)
This connector is for an IDE 100/66 signal cable, a blue connector for the
primary IDE connector on the motherboard
• Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.
R
P5L13L-X IDE Connector
NOTE: Orient the red markings
(usually zigzag) on the ID
ribbon cable to PIN 1.
PRI_IDE
PIN1
P5L13L-X