Troubleshooting – AEG HC451220EB User Manual

Page 30

Advertising
background image

7. TROUBLESHOOTING

Problem

Possible cause and remedy

You cannot activate the
appliance or operate it.

• You touched 2 or more sensor fields at the same

time. Only touch one sensor field.

• There is water or fat stains on the control panel.

Clean the control panel

• Activate the appliance again and set the heat set-

ting in 7 seconds.

• The child safety device or the lock or STOP+GO

operates. See the chapter Daily use.

A sound operates when
the appliance is deacti-
vated.

You put something on one or more sensor fields.
Remove the object from the sensor fields.

The residual heat indica-
tor does not come on.

The cooking zone is not hot because it operated
only for a short time. If the cooking zone must be
hot, speak to the service centre.

The heat setting changes
between two heat set-
tings.

The Power management is activated. See the sec-
tion Power management.

A sound operates and
appliance activates and
deactivates again. After
5 seconds one more
sound operates.

You put something

. Remove the object from the

sensor field.

comes on

• The Automatic Switch Off operates. Deactivate

the appliance and activate it again.

comes on

• No cookware on the cooking zone. Put cookware

on the cooking zone.

• Not correct cookware. Use the correct cookware.
• The diameter of the bottom of the cookware is

too small for the cooking zone. Move cookware
to a smaller cooking zone.

and number come

on.

There is an error in the appliance.
Disconnect the appliance from the electrical supply
for some time. Disconnect the fuse from the electri-
cal system of the house. Connect again. If

comes

on again, speak to the service centre.

comes on

There is an error in the appliance, because a cook-
ware boils dry. The protection against become too
hot for the cooking zone operates. The Automatic
Switch Off operates.
Deactivate the appliance. Remove the hot cook-
ware. After, approximately 30 seconds activate the
cooking zone again.

should go out of the dis-

play, residual heat indicator can stay. Let the cook-
ware become sufficiently cool and check it with the
section Cookware for the induction cooking zone.

30 www.aeg.com

Advertising
This manual is related to the following products: