Zanussi ZDT16011FA - Manual (Page 24)

Cleaning the filters
1
C
B
A
2
3
To remove filters (B)
and (C), turn the han-
dle counterclockwise
and remove. Pull
apart filter (B) and
(C). Wash the filters
with water.
A
4
Remove filter (A).
Wash the filter with
water.
D
A
5
Put filter (A) to its ini-
tial position. Make
sure that it assembles
correctly under the
two guides (D).
6
Assemble filters (B)
and (C). Put them in-
to position in filter
(A). Turn the handle
clockwise until it
locks.
An incorrect position of the filters can
cause bad washing results and damage to
the appliance.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged, re-
move remaining parts of soil with a thin pointed
object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use abra-
sive products, abrasive cleaning pads or sol-
vents.
Troubleshooting
The appliance does not start or it stops during
operation.
Before you contact the Service, refer to the in-
formation that follows for a solution to the prob-
lem.
With some problems, the display shows
an alarm code:
• - The appliance does not fill with water.
• - The appliance does not drain the wa-
ter.
• - The anti-flood device is on.
Warning! Deactivate the appliance before
you do the checks.
Problem Possible solution
You cannot activate the appliance. Make sure that the mains plug is connected to the mains
socket.
Make sure that there is not a damaged fuse in the fuse box.
24
www.zanussi.com