Zanussi ZDT16011FA - Manual (Page 26)

Problem Possible cause Possible solution
The set level of the water softener is
incorrect. Make sure that the set level of the wa-
ter softener agrees with the water
hardness in your area.
The cap of the salt container is loose. Tighten the cap.
Whitish streaks and stains
or bluish layers on glasses
and dishes. The released quantity of rinse aid is
too much. Decrease the released quantity of
rinse aid
.
The quantity of detergent was too
much. Make sure that you add the correct
quantity of detergent in the dispenser
before you start a programme.
Dry water drop stains on
glasses and dishes. The released quantity of rinse aid
was not sufficient . Increase the released quantity of rinse
aid.
The quality of the detergent can be
the cause. Try a different brand of detergent.
The dishes are wet. The programme had no drying phase. Set a programme with the drying
phase.
The dishes are wet and
matt. The rinse aid dispenser is empty. Make sure that there is rinse aid in the
rinse aid dispenser.
The quality of the rinse aid can be the
cause. Try a different brand of rinse aid.
The quality of the combi detergent
tablets can be the cause. • Try a different brand of combi deter-
gent tablets.
• Activate the rinse aid dispenser and
use the rinse aid together with the
combi detergent tablets.
Activating the rinse aid dispenser with the
multitab option activated
1. Press the on/off button to activate the appli-
ance. Make sure that the appliance is in set-
ting mode, refer to ‘SETTING AND START-
ING A PROGRAMME'.
2. Press and hold function buttons (B) and (C)
at the same time until the indicators of func-
tion buttons (A), (B) and (C) start to flash.
3. Press function button (B).
• The indicators of function buttons (A)
and (C) go off.
• The indicator of function button (B) con-
tinues to flash.
• The display shows the setting of the rinse
aid dispenser.
Off
On
4. Press function button (B) to change the
setting.
5. Deactivate the appliance to confirm the set-
ting.
6. Adjust the released quantity of rinse aid.
7. Fill the rinse aid dispenser.
Technical information
Dimensions Width / Height / Depth (mm) 596 / 818 - 898 / 596
26
www.zanussi.com