Zanussi ZDT16011FA - Manual (Page 25)

Problem Possible solution
The programme does not start. Make sure that the appliance door is closed.
If the delay start is set, cancel the setting or wait for the end
of the countdown.
The appliance does not fill with water. Make sure that the water tap is open.
Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clogged.
Make sure that the inlet hose has no kinks or bends.
The appliance does not drain the water. Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
The anti-flood device is on. Close the water tap and contact the Service.
After the checks are completed, activate the
appliance. The programme continues from the
point of interruption.
If the problem occurs again, contact the Serv-
ice. If the display shows other alarm codes, contact
the Service.
The washing results and drying results are not satisfactory
Problem Possible cause Possible solution
The dishes are not clean. The filters are clogged. Clean the filters.
The filters are not correctly assem-
bled and installed. Make sure that the filters are correctly
assembled and installed.
The spray arms are clogged. Remove remaining soil with a thin
pointed object.
The programme was not applicable
for the type of load and soil. Make sure that the programme is ap-
plicable for the type of load and soil.
Incorrect position of the items in the
baskets. Water could not wash all
items. Make sure that the position of the
items in the baskets is correct and that
the water can easily wash all items.
The spray arms could not turn freely. Make sure that the position of the
items in the baskets is correct and
does not cause the blockage of the
spray arms.
The quantity of detergent was not
sufficient. Make sure that you add the correct
quantity of detergent in the dispenser
before you start a programme.
There was no detergent in the deter-
gent dispenser. Make sure that you add detergent in
the dispenser before you start a pro-
gramme.
Limescale particles on the
dishes. The salt container is empty. Make sure that there is dishwasher salt
in the salt container.
25
www.zanussi.com