Asus V3-P5G965 - Manual (Page 61)

4-11 ASUS V-Series P5G965
9. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor
or switch. Connect one end of the chassis intrusion sensor or switch
cable to this connector. The chassis intrusion sensor or switch sends
a high-level signal to this connector when a chassis component
is removed or replaced. The signal is then generated as a chassis
intrusion event.
By default , the pin labeled “Chassis Signal” and “ Ground” are shorted
with a jumper cap. Remove the jumper caps only when you intend to
use the chassis intrusion detection feature.
10. IEEE 1394a port connector (10-1 pin IE1394_2)
This connector is for a IEEE 1394a port. Connect the IEEE 1394a
module cable to this connector, then install the module to a slot
opening at the back of the system chassis.
The IEEE 1394a module is purchased separately.
R
P5B-VM
Chassis Intrusion Connector
CHASSIS
+5VSB_M
B
Chassis Signal GND
(Default)
R
P5B-VM
IEEE 1394a Connector
IE1394_2
1
GND +12V TPB1- GND TP
A1-
+12V
TPB1+
GND
TP
A1+