Asus Pundit-R - Manual (Page 32)

32 Chapter 2: Basic installation
7
7. Re-install the storage drive
assembly, then secure it with the
screws you removed earlier.
To install a Serial ATA hard disk drive:
1. Follow steps 1-3 of the previous section.
2. Connect one end of the supplied
7-pin SATA cable to the
connector at the back of the
drive, then connect the other end
to the SATA connector on the motherboard. See page 64 for the
location of the Serial ATA connector.
3. For Serial ATA HDDs with a 4-pin power connector:
Connect a 4-pin (female) power plug from the power supply unit
(PSU) to the 4-pin (male) power connector at the back of the drive.
For Serial ATA HDDs without a 4-pin power connector:
Use the supplied SATA power
cable. Connect a 4-pin plug
(female) from the PSU to the
4-pin (male) plug of the SATA
power cable. Connect the 15-pin
SATA power plug to the power
connector at the back of the
drive.
Serial ATA cable
Serial ATA power cable
4-pin (male)
15-pin