Asus Terminator K7 - Manual (Page 107)

ASUS Terminator K7 Barebone System 107
Other Boot Device Select [INT18 Device (Network)]
Configuration options: [Disabled] [SCSI/Onboard ATA Boot Device]
[INT18 Device (Network)]
Plug & Play O/S [No]
This field allows you to use a Plug-and-Play (PnP) operating system
to configure the PCI bus slots instead of using the BIOS. When [Yes]
is selected, interrupts may be reassigned by the OS. When a non-
PnP OS is installed or you want to prevent reassigning of interrupt
settings, select the default setting of [No]. Configuration options: [No]
[Yes]
Reset Configuration Data [No]
The Extended System Configuration Data (ESCD) contain information
about non-PnP devices. It can also hold the complete record of how
the system was configured the last time it was booted. Select [Yes]
only if you want to clear these data during the Power-On Self Test
(POST). Configuration options: [No] [Yes]
Boot Virus Detection [Enabled]
This field allows you to set boot virus detection, ensuring a virus-free
boot sector. The system halts and displays a warning message when
it detects a virus. If this occurs, you can either allow the operation to
continue or use a virus-free bootable floppy disk to restart and
investigate your system. Configuration options: [Disabled] [Enabled]
Quick Power On Self Test [Enabled]
This field speeds up the Power-On-Self Test (POST) routine by
skipping retesting a second, third, and fourth time. Configuration
options: [Disabled] [Enabled]
Boot Up Floppy Seek [Disabled]
When enabled, the BIOS will seek the floppy disk drive to determine
whether the drive has 40 or 80 tracks. Configuration options: [Disabled]
[Enabled]
Onboard LAN Boot ROM
This system configuration is originally set to [Disabled]
APIC Mode
This function supports the operating system in multiprocessing (MP
OS). Configuration options: [Enabled] [Disabled]