Asus Terminator K7 - Manual (Page 27)

ASUS Terminator K7 Barebone System 27
2.8 Install a PCI Expansion Card
The motherboard has two 32-bit PCI slots (one shared with AMR
slot). If you wish to install a PCI card, refer to the instructions in this
section.
Follow these steps to install a PCI
expansion card.
1. Place the chassis on its side.
2. Remove the metal bracket
cover opposite the PCI slot
marked PCI1.
The figure on the right shows a
sample PCI network card that you
can install on the PCI slot.
3. Align the PCI card golden
fingers to the PCI slot and its
metal bracket to the slot
opening on the chassis.
4. Press the card firmly until the
it is properly seated on the
slot.
5. Secure the card to the chassis
with a bracket screw.
NOTE
If you have installed a
modem riser card, PCI2 is
not available.
PCI Slot 1 (PCI1) Slot Opening
for PCI1
PCI Slot 2 (PCI2)