Asus Terminator P4 533A - Manual (Page 29)

ASUS Terminator P4 533A Barebone System 29
2.9 Re-connect cables
You may have disconnected some cables when you were installing
components. You must re-connect these cables before you replace the
chassis cover.
2.9.1 LED cables
• Connect the power switch and power LED cables to their respective
leads in the PANEL1 connector on the motherboard.
• Connect the HDD LED cable to the 2-pin lead marked IDE_LED1.
Power Switch
Power LED
HDD LED
PANEL1
IDE_LED1
* Requires an ATX power supply.
PLED
Ground
MLED PWR
+5VSB +5V Speaker
Speaker
Connector
Power LED
Ground
+5 V
Reset SW
SMI Lead
Message LED
ExtSMI#
Ground Reset
Ground Ground
ATX Power
Switch*
PANEL1 Connector