Asus AAM6020VI-T4 User Manual
Page 11
AAM6020VI-T4 User Manual
11
11
3.2.5
Windows NT 4.0:
1. In the Windows NT task bar, click on the Start button, point to Settings, and then click Control
Panel.
2. In
the
Control Panel window, double click on the Network icon.
3. In
the
Network dialog box, click on the Protocols tab.
The Protocols tab displays a list of currently installed network protocols. If the list includes TCP/IP,
the protocol has already been enabled, in which case you can skip to Step 9.
4. If
TCP/IP does not appear as an installed component, click on
.
5. In
the
Select Network Protocol dialog box, select TCP/IP, and then click on
.
You may be prompted to install files from your Windows NT installation CD or other media. Follow
the instructions to install the files.
After all files are installed, a window displays to inform you that a TCP/IP service called DHCP can be
set up to dynamically assign IP information.
6. Click
on
to continue, and then click on
if prompted to restart your
computer.
7. After restarting your PC, open the Control Panel window, and then double-click on the Network
icon.
8. In
the
Network dialog box, click on the Protocols tab.
9. In
the
Protocols tab, select TCP/IP, and then click on
.
10. In the Microsoft TCP/IP Properties dialog box, click in the radio button labeled Use the
following IP address and type 192.168.1.x (where x is any number between 2 and 254) and
255.255.255.0 in the IP address field and Subnet Mask field, respectively.
11. Click on
twice to confirm and save your changes, and then close the Control Panel.
3.2.6
Assigning IP to your PC automatically by DHCP
To use the CPE’s DHCP feature, click in the radio button labeled Obtain an IP address automatically
instead of Use the following IP address in the above procedures.
By default, the LAN port IP address of the CPE is 192.168.1.1. (You can change this address, or
another address can be assigned by your ISP.)
Now that the hardware installation is complete, proceed to Chapter 4: Setting up your CPE