Asus T2-PH1 - Manual (Page 42)

2 - 2 2 2 - 2 2 2 - 2 2 2 - 2 2 2 - 2 2 C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n
To install a Serial ATA hard disk drive:
1. Follow steps 1-7 of the previous section.
2. Connect one end of the supplied
7-pin SATA cable (right angle
side) to the SATA connector at
the back of the drive, then
connect the other end to a
SATA connector on the
motherboard. See page 4-12 for
the location of the Serial ATA
connectors.
2 2 2 2 2
2 2 2 2 2
3a 3a 3a 3a 3a
3 3 3 3 3b b b b b
1 5 - p i n S A T A 1 5 - p i n S A T A 1 5 - p i n S A T A 1 5 - p i n S A T A 1 5 - p i n S A T A
p o w e r p l u g
p o w e r p l u g p o w e r p l u g p o w e r p l u g p o w e r p l u g
4 - p i n ( m a l e ) 4 - p i n ( m a l e ) 4 - p i n ( m a l e ) 4 - p i n ( m a l e ) 4 - p i n ( m a l e )
p o w e r p l u g
p o w e r p l u g p o w e r p l u g p o w e r p l u g p o w e r p l u g
If your Serial ATA HDD has both 4-pin and 15-pin connectors at the
back, use either the 15-pin SATA power adapter plug O R
O R O R O R O R the legacy
4-pin power connector. D O N O T D O N O T D O N O T D O N O T D O N O T use both to prevent damage to
components and to keep the system from becoming unstable.
3. For Serial ATA HDDs with a
4
-pin power connector:
a. Connect a 4-pin (female) power plug from the power supply unit
to the 4-pin (male) power connector at the back of the drive. See
page 2-24 for details on the power supply unit plugs.
For Serial ATA HDDs without a 4 -pin power connector:
b. Connect the 15-pin SATA power adapter plug to the power
connector at the back of the drive, then connect the other end
(4-pin male) to a 4-pin (female) power plug from the power
supply unit. See page 2-24 for details on the power supply unit
plugs.