Armasight ANKI000049 AIM PRO-L Advanced Integrated Mount - Manual (Page 22)

22
Figure 3-4 shows the fully-assembled AIM-PRO-L connected to the NYX-14
Night Vision Monocular with a 3X afocal lens.
FIGURE 3-3. AIM-PRO ASSEMBLED WITH NYX-14 NIGHT VISION MONOCULAR
FIGURE 3-4. AIM-PRO-L ASSEMBLED WITH NYX-14 WITH 3X LENS
For instructions on positioning the AIM-PRO collimator, see Part 3.1.2 (Col-
limator Installation).
Mount the NVM to the AIM-PRO as follows:
1. If necessary, reposition the collimator on the AIM-PRO mount as per Part
3.1.2.
2. To unlock the clamping device (located on top of the mount), see Figure
3-4. While pushing the lever holder (C) down, turn the lever (B) towards
the arrow (forward).
3. Install the NVM on the mount so that the stop (A) is inserted into the
transverse slot of the NVM rail.
4. Secure the NVM to the mount by turning the lever (B) to the locked posi-
tion, as shown in Figure 3-4.