7 clamping device adjustment – Armasight ANKI000049 AIM PRO-L Advanced Integrated Mount User Manual
Page 26
26
C
B
A
FIGURE 3-9. CLAMPING DEVICE ON THE MOUNT UNDERSIDE
3.1.7 CLAMPING DEVICE ADJUSTMENT
Adjustment procedures are identical for both of the AIM-PRO clamping de-
vices.
Adjust the holding power of the AIM-PRO clamping device as follows:
1. In order to detach the clamping device, remove the NVM/ 3X Magnifier
from the AIM-PRO, or remove the AIM-PRO from the weapon.
2. With the clamping device (A) unlocked (as shown in Figure 3-10), push the
cam (B) towards the arrow so that the nut (C) is released from the hole.
3. To tighten/ loosen the clamping device, push down on the cam (B) and
turn the nut (C) CW or CCW, respectively, by one-two increments (see
note below). When the cam (B) is released, the backward-moving springs
will push the nut (C) back into the hole.
B
C
FIGURE 3-10. CLAMPING DEVICE ADJUSTMENT
A
B
C
A