AVSL 153.770 ILA2 - Manual (Page 2)

Controls
 To switch LEDs on or off, press and hold Speed/Dim/On button
for 2 seconds
 Mode button steps through the 8 preset programmes in
sequence (shown below)
 Pressing the Speed/Dim/On button in a pattern cycles through
various speed settings (10 in total)
 Pressing the Static/Light button switches mode from pattern to
static – repeated presses increase brightness
 Pressing Speed/Dim/On in static mode dims the LEDs
Preset Name Description
1 Random Glow Fade in and out at random brightness & intervals
2 Regular Glow Fade between fully on and off at a regular rate
3 Half Glow Fade between fully on and half-on at a regular rate
4 Flicker Flash on and off at a fast regular rate
5 Offset Flash Flash on and off with pause at a regular rate
6 Even Flash Flash on and off evenly at a regular rate
7 SOS 3 short - 3 long - 3 short Morse Code flash sequence
8 Strobe Very short burst at regular intervals
ILA2
For extended runs beyond 15m, it is necessary to use the ILA2 single colour amplifier/repeater
to provide power and control to the further lengths of LED tape.
Specifications
Power supply (input/output) 5-24Vdc, 12A max (short term)
Lead length (input/output) 100mm
Controller dimensions 42 x 13 x 5mm
Weight 7.2g
Errors and omissions excepted.
Copyright© 2014. AVSL Group Ltd.