AVSL 153.770 ILA2 - Manual (Page 8)

153.699UK User Manual
Remote control
12. POWER LED on / standby button
13. MODE+ steps upwards through modes
14. SPEED- reduces speed of pattern
15. COLOR+ steps upwards through colours
16. COLOR- steps downwards through colours
17. DEMO initiates the demo mode
18. SPEED+ increases speed of pattern
19. MODE- steps downwards through modes
20. BRIGHT+ increases brightness
21. BRIGHT- decreases brightness
 Remove the clear tab from the handheld remote to engage the battery (replacement CR2025 button cell)
 To switch LEDs on, press the POWER button (from standby, the last setting is resumed)
 If there is no response handset to the controller (see from the handset, it may be necessary to pair the “Pairing” below)
 To test all LED functions, pressing the DEMO button will initiate a full demo programme
 MODE+ and - buttons step through the 19 preset programmes in sequence (shown below)
 SPEED+ or - will alter the rate of change in the selected mode
 COLOR+ or - will override the pattern mode and step through 20 static colours
 BRIGHT+ or - will change the brightness of the selected colour
 Press POWER to enter standby mode (all LEDs off)
Pairing: If the LED controller does not respond to the RF remote handset, disconnect DC power from the controller.
Reconnect the DC power to the controller and within 5 seconds of powering on, hold down the “SPEED-” and “SPEED+”
buttons simultaneously.
The controller and handset should now be paired and the controller should respond to the handset.
Preset Name Description
1 - 2 Scrolls 2 types of scrolls through full spectrum of colours
3 RGB Glow Fade between fully on and half through Red, Green, Blue
4 7 Colour Glow Fade between fully on and half through 7 different colours
5 - 10 Static Glows Glow presets for Blue, Cyan, Green, Red, White
11 RGB Jump Switch between Red, Green and Blue
12 6 Colour Jump Switch between 6 different colours
13 RGB Flash Flash on and off through Red, Green and Blue
14 - 18 Static Strobes Regular, very short burst for Blue, Cyan, Green, Red, White
19 RGB Strobe Regular, very short burst through Red, Green, Blue
Specifications
Power supply
5-24Vdc, 12A (to supply 3 x 4A max – 50% duty cycle)
Remote control frequency 433MHz
Lead length (power input) 100mm
Connections 4-pin socket (Common+ / Green / Red / Blue)
Controller dimensions 42 x 13 x 5mm
Weight 4.8g
Errors and omissions excepted.
Copyright© 2014. AVSL Group Ltd.