AVSL 154.095 DM-X24 - Manual (Page 17)

16/19 USER MANUAL
Chase is too slow
Device has no
Power
Fixture is not
responding
Fixture is on but
there is no
movement to the
audio
Lamp cuts off
Sporadically
Light will not come
on after power
failure
Loss of singnal
Moves slow
No flash
No light output
No light output
Relay will not work
Remote does not
work
Stand alone mode
Check users manual for speed
adjustment
Check for power on mains.
Check device S fuse.(intemal and/or
external)
Check DMX Dip switch setting for
Correct addreesing
Check DMX cables
Check polarity switch settings
Make sure you have the correct
audio mode on the control switches.
If audio provided via1/4 jack make
suer a live audio signal exists.
Adjust sound sensitivity knob.
Possible bad lamp or fixture is
Overheating.
Lamp may be lamp end of its life.
Some discharge lamps require a
cooling off period before the
electronics in the fixture can kick
Start it again, wait 5 to 10 minutes
Before powering up.
Use only DMX cables
Install terminator
Note: Keep DMX cables separated
From power cables or black lights.
Check 200V/11V switch for proper
Setting.
Re-install bulb, may have shifted in
Shipping, readjust
Bounce mirror motor may have
Shifted during shipping
Check slip ring & brushes for contact
Install bulb
Call service technician
Check reset switch
Check cable connections
Make sure connection is firmly
connected to device
All lighting fixtures featuring
Standalone function do not require
additional settings, simply power the
fixture and it will automatically enter
into this mode
DMX 512 CONTROLLER SERIES