C2G 29505 WIRELESS DIGITAL SIGNAGE DISTRIBUTION SYSTEM - Manual (Page 16)

15
This section explains the necessary actions that should be taken before you connect and setup this product.
3.1 N
ECESSARY
I
TEMS
Following items are required for the system architecture.
WDSDS
Transmitter At least one transmitter is required.
WDSDS Receiver As many WDSDS Receivers as you need for your environment. Each Receiver supports one monitor,
and up to 32 Receivers can be connected for a single WDSDS Transmitter.
Media Player A media player (or PC) with DVI-I (DVI-D, Analog RGB, Component) interfaces. It should support the
same video resolution level as this product.
Monitor A monitor with DVI-I (DVI-D, Analog RGB, Component) interfaces. It should support the same video
resolution level as this product. (As many monitors as WDSDS Receivers are required.)
Speaker
As many speakers as WDSDS Receivers are required.
(Not necessary if the speaker is embedded to the
monitor.)
Display Cable
Display cable with DVI-I connector (male/male) and noise suppression.
One cable is required for each WDSDS Transmitter and Receiver.
Also, when you connect the media players or monitors with analog RGB or component interface to
this product, the adapter (or cable) that can convert those interfaces to DVI-I is required.
Audio Cable Audio cable with RCA pin plug connector and noise suppression.
One cable is required for each WDSDS Transmitter and Receiver.
Antenna One antenna is required for each Transmitter and Receiver. 2dB antenna is bundled with the
WDSDS, but you may need to use more specialized antennas to provide better performance. In such
case, use the antenna appropriate for your location status, distance from the Receiver or layout.
The Transmitter and Receiver have 2 antenna terminals. You can use both terminals as they
automatically recognize which terminal is in use. The antenna is not required during the installation.
PC
(used for setup) A PC with a wired LAN (100 BASE-TX) port.
LAN cable
(used for setup) Category 5 or better LAN cables to connect the PC to WDSDS Transmitter and Receiver
during the configuration.
-Either straight cable or crossover cable can be used since Auto MDI/MDI-X is supported.
-Ethernet Hub can be used, but is not required.
3.0 I
NSTALLATION