C2G 29505 WIRELESS DIGITAL SIGNAGE DISTRIBUTION SYSTEM - Manual (Page 19)

18
C ONFIGURE E ACH P ARAMETER
After you have assigned the IP address to this product, configure the network parameters
from the Web page of this product. The Web page can be accessed using a standard web
browser or from the WDSDS Locator.
Note: The PC must be configured with a unique IP address that is compatible with the IP
address used by this product (for example, if this product has an IP address of
“169.254.3.111”, the PC could have an IP address such as “169.254.3.1”, assuming that
this address is not used by other devices).
H
OW TO ACCESS THE W EB PAGE
1. Start WDSDS Locator and select the device in the list that you wish configure.
2. Select NodeÆ Open Web interface.
3. Web page of this product is displayed.
Note:
In the Web page, when Configuration or Tools page is accessed, a password authentication dialog is
displayed. Enter “root” for User name and the password that you have configured to this product for
Password. (By factory default, no password is set.)
H
OST N AME AND P ASSWORD
By factory default, the last six digits of the Ethernet address is used as the host name of the
WDSDS Transmitter and Receiver. You can change the host name when desired, but
make sure that it is a unique name.
1. Click Configuration – Basic in the left pane.
2. In the page displayed, enter the host name and password to Host Name and Access
Password respectively.
3.3 P RODUCT C ONFIGURATION