Acer AR360 F1 - Manual (Page 45)

29
Removal and replacement
procedures
Required tools
You need the following items for some procedures:
•
T-10/T-15 Torx screwdriver (included with the server)
Preparation procedures
To access some components and perform certain service procedures,
you must perform one or more of the
following procedures:
•
Extend the server from the rack
If you are performing service procedures in an Acer branded, telco,
or third-party rack cabinet, you can use the locking feature of the
rack rails to support the server and gain access to internal
components.
For more information about telco rack solutions, refer to the
RackSolutions.com website
• Power down the server
If you must remove a server from a rack or a non-hot-plug
component from a server, power downthe server.
• Remove the server from the rack
If the rack environment, cabling configuration, or the server
location in the rack creates awkward conditions, remove the server
from the rack.
• Access the product rear panel
If you are performing certain service procedures, access the
product rear panel
Extend the server from the rack
1 If the server is screwed into the rack, remove the screws and set
them aside.
2 Grasp the handles and extend the server from the rack.