Xylem A-100NE CHEMICAL PUMPS - Manual (Page 9)

A-100NE
Page 9
CAUTION: Proper eye and skin protection must be
worn when installing and servicing the pump.
6.0 How to operate the pump
6.1 Pump Output Controls -
Open the control panel door by sliding the
upper and lower slide clamps to the left.
! RUN/STANDBY Button -
+
Press to start and stop the pump.
ARROW next to the word RUN will light
when in the run mode. The ARROW next
to the word
STAND-BY will blink when in
the stand-by mode.
The
+
Press to clear ALARM.
+
When pressed with the FIELD Button, initiates a 99 second prime cycle
which temporarily overrides the mode setting and runs the pump motor at
100% speed. The ARROW next to the word
PRIME will blink.
+
When pressed with the DIGIT button, resets the 500 hour service warning
timer to zero.
+
When pressed with the MODE button, initiates the programming mode.
The ARROW next to the word
PROGRAM will blink.
! FIELD Button -
+
In the programming mode, selects the digit to be changed.
! DIGIT Button -
+
In the programming mode, increases the selected digit.
+
When pressed with the MODE Button, toggles the display from operating
time cycle values to input signal value.
! MODE Button -
+
Used to select one of five operating modes.
Mode 0 - TFD system and FVS system set-up
Mode 1 - Manual Adjustment (external input disabled)
Mode 2 - 4-20mA input
Mode 3 - 0-10VDC input
Mode 4 - Frequency input adjusts cycle on-time
Mode 5 - Pulse input count = single batch time
RUN
STANDBY
RUN FIELD DIGIT MODE
PROGRAM
STAND-BY
PRIME
MINIMUM
MAXIMUM
INPUT MODES
1 - MANUAL 2 - 4-20mA 3 - 0-10VDC
4 - 0-1000 Hz
PROGRAM
RESET SERVICE
PRIME
DISPLAY
DIGITAL TIMER PUMP
1
VDC
SERVICE
1000
ALARM
mA Hz
MODE
TFDFVS
ON-TTOT-TSECMINHRDAY
5 - PULSE (BATCH)
RUN
STANDBY
RUN FIELD DIGIT MODE
PROGRAM
STAND-BY
PRIME
MINIMUM
MAXIMUM
INPUT MODES
1 - MANUAL 2 - 4-20mA 3 - 0-10VDC
4 - 0-1000 Hz
PROGRAM
RESET SERVICE
PRIME
DISPLAY
DIGITAL TIMER PUMP
1
VDC
SERVICE
1000
ALARM
mA Hz MODE
TFDFVS ON-TTOT-TSECMINHRDAY
5 - PULSE (BATCH)
SLIDE CLAMP