Extron Electronics CrossPoint 42 HVA - Manual (Page 12)

Installation, cont’d
CrossPoint 42 HVA Matrix Switcher • Installation 2-2
Installation
Mounting the Switcher
The CrossPoint 42 HVA Matrix Switcher is housed in a rack-mountable, 1U high,
19” wide metal enclosure. The appropriate rack mount kit (#70-077-03) is included
with the switcher. The switcher may also be surface-mounted under a table, desk,
or podium, or on a wall, using an Extron 1U underdesk mounting kit (#70-222-01).
Table or wall mounting
The table/wall mounting brackets extend approximately 1/4” (6.4 mm) above the
top surface of the switcher enclosure. This design allows for an air space between
the enclosure and the surface to which it is mounted. Table or wall mount the
switcher as follows:
1 . Attach the table/wall mounting brackets to the switcher with the eight
provided #8 machine screws (figure 2-1).
2 . Hold the switcher with the attached brackets against the underside of the
table or other furniture, or against the wall. Mark the location of the
screw holes of the bracket on the mounting surface.
3 . Drill 3/32” (2 mm) diameter pilot holes, 1/4” (6.4 mm) deep in the
mounting surface at the marked screw locations.
4 . Insert #8 wood screws into the four pilot holes. Tighten each screw into
the mounting surface until just less than 1/4” of the screw protrudes.
5 . Align the mounting screws with the slots in the brackets and place the
switcher against the surface, with the screws through the bracket slots.
6 . Slide the switcher slightly forward or back, then tighten all four screws to
secure the switcher in place.
Figure 2-1 — Mounting the CrossPoint 42 HVA Switcher
RS232
AUDIO INPUTS
AUDIO
OUTPUTS
L
R
L
R
L
R
1
2
1
3
4
2
1.5A MAX R 1
2
G
B
H
V
R
G
B
H
V
INPUTS
OUTPUTS R
G
B
H
V
100-240V 50-60Hz
3
4
1
2
H V H V
H V H V
1
ON
2 3 4
#8 Screw (4 Plcs) Each Side
Mounting Screws (2 Plcs)
Each Side
or