Controlling multiple amplifiers with one, Volume controller – Extron Electronics XTRA Series User Manual

Page 24

Advertising
background image

Controlling Multiple Amplifiers with One Volume Controller

Several XPA 1002 and XPA 2001 series units can be daisy-chained so that one volume
controller can simultaneously regulate the volume of all the amplifiers.

NOTES:

As additional amplifiers are added to the daisy chain, the sensitivity of the
volume potentiometer will change. The maximum volume level (fully clockwise)
will not be affected. However, the effectiveness of the minimum volume level
(fully counterclockwise) in reducing the volume to inaudible levels decreases as
more amplifiers are added to the daisy chain.

When more than two XPA Half-Rack units are attached to the chain, sound may
be heard even if the levels have been set to their lowest. If complete muting is
required, use a contact closure switch attached between the C (Vol/Mute) and
the G (ground) pins of the first XPA Half-Rack unit in the chain.

To regulate multiple amplifiers with a single volume controller:

1.

Attach all three pins of the volume controller to the corresponding pins on the first
XPA Half-Rack unit only — Ground to G (ground), Vol/Mute to C (Vol/Mute),
and 10 V to V (10 V).

2.

Use jumper wires to connect the C (Vol/Mute) pins of the first amplifier and each
successive amplifier.

3.

Use jumper wires to connect the G (ground) pins of the first amplifier and each
successive amplifier.

VOL/ MUTE

10V

REMOTE

G

G

C

V

10V

50mA

ST

ANDBY

REMOTE

G

G

C

V

10V

50mA

ST

ANDBY

Extron
VCM 100 AAP

Extron
XPA Half-Rack
daisy chain

1 2 3 4 5

STANDBY

VOL/MUTE

10V

50 mA

1 2 3 4 5

STANDBY

VOL/MUTE

10V

50 mA

1 2 3 4 5

STANDBY

VOL/MUTE

10V

50 mA

or

1 2 3 4 5

VOL/MUTE

10V

50 mA

STANDBY

1 2 3 4 5

VOL/MUTE

10V

50 mA

STANDBY

1 2 3 4 5

VOL/MUTE

10V

50 mA

STANDBY

REMOTE

G

G

C

V

10V

50mA

ST

ANDBY

Figure 9.

Regulating Multiple Amplifiers with a Single Volume Controller

NOTE: The 10 V pin of the volume controller connects to the first XPA Half-Rack

unit only. There are no jumper wires linking it to subsequent amplifiers.

XTRA Series Half-Rack Audio Power Amplifiers • Operation

18

Advertising