Extron Electronics FLS 101 User Guide - Manual (Page 3)

iii
Conventions Used in this Guide
TIP: A tip provides a suggestion to make setting up or working with the device easier.
NOTE: A note draws attention to important information.
CAUTION: A caution indicates a potential hazard to equipment or data.
WARNING: A warning warns of things or actions that might cause injury, death, or
other severe consequences.
Copyright
© 2011 Extron Electronics. All rights reserved.
Trademarks
All trademarks mentioned in this guide are the properties of their respective owners.
Copyright, and Trademark Infor-
mation
WARNING: Use of controls or adjustments other than those specified in this guide
may result in hazardous radiation exposure.
The FLS 101 optical light source is a registered Class I LED and Laser Product.
WARNING: To avoid the danger of fire and electrical shock:
• Never use a voltage that is different from that for which the AC
adapter is rated.
• Do not plug the unit into a power outlet that is shared by other
devices.
• Never modify the power cord or excessively bend, twist, or pull
it.
• Do not allow the power cord to become damaged. Do not place
heavy objects on the power cord or expose it to heat.
• Never touch the AC adapter while your hands are wet.
• Should the power cord become seriously damaged (internal
wiring exposed or shorted),contact the manufacturer to request
servicing.
Use only the specified AC adapter. Use of another type of AC adapter
can damage the instrument and create the danger of fire and electrical
shock.
To avoid serious eye injury, never look directly into the optical outputs
of fiber optic network equipment, test equipment, patch cords, or test
reference cables. Always assume that optical outputs are on.
CAUTION: Proper care in handling should be taken when using any precision
optical test equipment. Scratched or contaminated optical connectors
can impact the performance of the instrument. It is important to keep
the dust caps in place when the unit is not being used.
NOTE: Extron power meters and light sources contain no user serviceable parts.
Except for changing batteries and cleaning optical ports, these units must be
returned to Extron or authorized agents for repair and calibration.
CLASS 1 LED
PRODUCT