Extron Electronics HDMI 201 - Manual (Page 11)

1U Universal Rack Shelf
Figure 3. Mounting the Transmitter or Receiver on a Universal Rack Shelf
Furniture mounting
Under-furniture mounting
The unit can be mounted under a horizontal surface using an optional MBU 125 under-
desk mounting kit (part #70-077-01). Mount the unit under a desk or table as follows:
1. Remove feet from the bottom of the HDMI 201 unit if installed.
2. Secure the under-desk mounting brackets to the transmitter or receiver with the four
machine screws provided in the mounting kit (figure 4).
Figure 4. Under-Desk Mounting
3. Hold the transmitter or receiver with attached brackets against the underside of the
desk or other furniture. Mark the location of holes for screws on the desk.
4. Drill 1/4-inch (6.4 mm) deep, 3/32-inch (2 mm) diameter pilot holes in the table or
desk at the marked screw locations from the underside or inside (the concealed side)
of the furniture, where the transmitter or receiver will be located.
5. Insert the four wood screws into the pilot holes. Fasten each screw into the
installation surface until just less than 1/4 inch of the screw head protrudes.
6. Align the installed screws with the slots in the mounting brackets, and place the
transmitter or receiver against the surface, with the screws through the bracket slots.
7. Slide the transmitter or receiver slightly forward or back, then tighten all four screws
to fasten it in place.
HDMI 201 • Installation and Operation 7