Extron Electronics HDMI 201 - Manual (Page 27)

Terminating shielded cable
The Tx and Rx each include two shielded RJ-45 connectors and a length of self-adhesive
shielded tape that you can use to make the STP cables that connect the transmitter and
receiver.
NOTES: • The transmitter and receiver pair works with unshielded twisted pair (UTP)
or shielded twisted pair (STP) cables; but, to ensure FCC Class A and CE
compliance, STP cables are required.
• Extron supplies the connectors and the shielded tape. You must supply the
CAT 5, 5e, 6, or DTP26 cable.
Terminate the STP cable as follows:
1. Peel back the cable shielding (figure 22) from the end of the cable the length of the
RJ-45 connector body (approximately 7/8 inch [2.2 cm]) and fold it back.
Peel back shield and
fold back.
Figure 22. Peeling Back the Cable Shielding
2. Cut away and discard the clear cellophane inner wrapper from the end of the cable
back to the folded-over cable shielding.
3. Peel the backing off the self-adhesive shielded aluminum tape and wrap it around
the folded-over cable shielding, slightly overlapping the beginning of the tape
(figure 23).
Aluminum Tape
Wrap tape around folded foil shielding.
Slightly overlap.
Cut and save the excess tape
for other connectors.
Figure 23. Wrapping the Shielded Tape
4. Cut the unused portion of the shielded tape and retain for shielding other RJ-45
connectors.
5. Feed each individual wire into the appropriate slot of the RJ-45 connector and crimp
the cable in the normal manner, folding the tangs at the end of the connector over
the shielded tape (figure 24).
Crimped Connector
Figure 24. Crimped RJ-45 Connector
HDMI 201 • Installation and Operation 23