Extron Electronics HDMI 201 - Manual (Page 13)

Projector mounting
The receiver can be mounted on a projector bracket using either of the following optional
Extron projector mounting kits:
• PMK 300 multi-product pole mount kit (part #70-374-01)
• PMK 350 low profile, multi-product pole mount kit (part #70-563-02 [black] or
part #70-563-03 [white])
PMK 300 mounting
Mount the receiver to a PMK 300 bracket as follows:
1. If necessary, remove the feet from the bottom of the receiver.
2. Mount the receiver to one of the three mounting plates on the bracket using two
of the supplied 4-40 x 3/16-inch screws in opposite (diagonal) corners to secure the
device to the bracket. It can be vertically mounted facing either up or down (figure 6).
Extron
PMK 300
Multi-product Pole Mount Kit
U-Bolt
Front Mounting
Plate
Side Mounting
Plate
Extron
DVI 201 or HDMI 201
Receiver
Power Supply
Bracket
Brace
Figure 6. PMK 300 Projector Mounting a Receiver
NOTE: On the side mounting plates, the device is typically mounted on the outside
of the bracket.
On the front mounting plate, the device is typically mounted on the inside
of the bracket.
3. If the power supply is connected to the receiver, use the two included tie wraps
to strap the power supply to one of the brackets.
HDMI 201 • Installation and Operation 9