Extron Electronics HDMI 201 - Manual (Page 24)

HDMI 201 A D Rx Front Panel
OUTPUT
Rx
Tx
RS-232
PASS THRU
AUDIO-R
HDMI
AUDIO-L
10
12
9
Figure 18. HDMI 201 A D Rx Front Panel Connectors
h Receiver input ports — Connect one end of the two separate TP cables from the
transmitter output connectors ( item e on page 18) to these RJ-45 female connectors.
CAUTION: Do not connect this device to a computer data or telecommunications
network.
Connect the free ends of the same TP cables from the receiver to the female Output
RJ-45 connectors (
item e on page 18) on the transmitter.
See TP cable termination to properly wire the RJ-45 connectors.
NOTE: • Extron recommends 28AWG to 24AWG TP cable for the RJ-45
connectors.
• For resolutions of 1600x1200, 1920x1200, and 1080p, Extron strongly
recommends DTP26 cable, or equivalent.
• Connect transmitter output 1 to receiver input 1. Connect transmitter
output 2 to receiver input 2.
• If necessary, test for proper cable connection (output 1 to input 1,
output 2 to input 2) as follows:
1. Plug both TP cables into the powered unit.
2. Momentarily connect either of the cables on the opposite end into
the “2” connector on the unpowered unit.
If the Power LED on the unpowered unit is lit, the connection is
correct.
If the Power LED on the unpowered unit is not lit, unplug the
connector on the unpowered end and connect the other cable to
the “2” connector.
i
HDMI Output connector — Connect an HDMI display for the transmitted direct
digital image. See HDMI connector pin assignments for pin assignments.
HDMI 201 • Installation and Operation 20