Extron Electronics RCP 2000 - Manual (Page 11)

RCP 2000 • Operation
Operation, cont’d
RCP 2000 • Operation 3-4
Wipe button (SGS only) — Causes the preview image to
appear to unroll over the program image horizontally or
vertically. The different wipe effects include standard,
curtain, plus, square, and title window.
Take button — Initiates the switch selected through the
switching effect buttons.
For further information, see Applying and Changing a Switching
Effect, later in this chapter.
9 T-bar controller — Allows you to manually override the
duration of an effect by pulling on the T-bar handle. See
Applying and Changing a Switching Effect, later in this chapter.
10 Picture control buttons — Allow you to make adjustments to
the picture for either the program or the preview output. The
five control buttons control color and tint, contrast and
brightness (Cont/Bright), sizing (Size), centering (Center), and
detail. These buttons light when pressed. See Using the Picture
Controls, later in this chapter.
After an input is selected, press the desired picture control
button, then rotate the appropriate encoder knob
11 or 12
while viewing the output display. You can adjust the centering,
sizing, and detail horizontally or vertically using the horizontal
(H) and vertical (V) adjustment knobs. Contrast and color are
adjusted using the H knob; brightness and tint are adjusted
using the V knob.
11 Horizontal adjustment knob (H) — Allows horizontal
adjustments to the centering, sizing, and detail picture controls.
Contrast and color are also adjusted using this knob. After
selecting an input, press the desired picture control button and
rotate this knob to make the adjustment.
12 Vertical adjustment knob (V) — Allows vertical adjustments to
the centering, sizing, and detail picture controls. Brightness and
tint are also adjusted using this knob. After selecting an input,
press the desired picture control button and rotate this knob to
make the adjustment.
Using the Picture Controls
The picture controls allow you to adjust the centering, size,
detail, contrast/brightness, and color/tint of the preview image.
Adjusting color and tint
To adjust the color and tint of an image, do the following:
1 . Press and release the Color/Tint button. The button lights.
2 . To change the color, rotate the H adjustment knob.
3 . To change the tint, rotate the V adjustment knob.
Adjusting contrast and brightness
To adjust the contrast and brightness of an image, do the
following:
1 . Press and release the Cont/Bright button. The button
lights.
2 . To change the contrast, rotate the H adjustment knob.
3 . To change the brightness, rotate the V adjustment knob.
Sizing an image
To adjust the image size, do the following:
1 . Press and release the Size button. The button lights.
2 . To adjust the vertical size (height), rotate the V adjustment
knob.
3 . To adjust the horizontal size (width), rotate the H
adjustment knob.
Centering an image
To adjust the image centering, do the following:
1 . Press and release the Center button. The button lights.
2 . To adjust the vertical centering, rotate the V adjustment
knob.
3 . To adjust the horizontal centering, rotate the H adjustment
knob.
3-5