Extron Electronics RCP 2000 - Manual (Page 19)

RCP 2000 • Remote Control
Remote Control, cont’d
RCP 2000 • Remote Control 4-8 4-9
File management
The File Management screen is used to upload new files (for
custom or updated Web pages) to the RCP unit and to delete
existing files from the unit. The File Management screen can be
accessed from the initial (System Status) screen.
To upload new files or delete existing files:
1 . Select the File Management tab. The File Management
screen (figure 4-6) opens.
Figure 4-6 — File Management screen
2 . To upload new files to the RCP unit, click the Browse
button. Find the file(s) on the control PC, networked
computer, or networked server, and select (highlight) the
file(s).
3 . Click the Upload File button to upload the file to the RCP
unit. Note the file name restrictions mentioned in the
instructions.
4 . To delete a file from the RCP unit, find the file on the file
list and select the Delete check box. When you are ready
to delete the selected file(s), click the Delete Files button.
Network Switcher Control
In addition to network configuration, passwords, file
management, and similar tasks, the Web server can also be used
to control an ISS 108/408.
Accessing network switcher control
To access network switcher control:
1 . Double-click the Web browser icon on your Windows
desktop to launch your Web browser.
2 . Enter the IP address of the RCP unit (see Changing the IP
addresses, earlier in this chapter) in the address field at the
top of the screen, and press the Enter key. The Password
window is opened if a password has been set. (This does
not happen the first time you access the interface, because
no password is set at the factory).
3 . Enter the appropriate password (if required). The System
Status page opens (figure 4-3), showing the current IP
address and other settings of the unit.
4 . Select the Configuration tab. The System Settings screen
(figure 4-4) opens.
5 . At the bottom of the System Settings screen, in the
Controlled Switcher area, enter the IP address of the
switcher to be controlled (in the IP Address field); then
click the Submit button.
6 . Once the IP address of the switcher has been set, click the
Control button. The switcher Control screen (figure 4-7)
opens.
I/O Configuration should be completed in accordance
with the user’s manual for your switcher. System
Configuration and File Management information is also
available in the user’s manual specific to your switcher;
however, the information presented in the Establishing
or changing system settings and File Management
sections of this manual are generally applicable.