Extron Electronics RCP 2000 - Manual (Page 4)

RCP 2000 • Quick Start Guide
Quick Start Guide — RCP 2000, cont’d
iii RCP 2000 • Table of Contents
Chapter 1 • Introduction .......................................................... 1-1
Features ...................................................................................... 1-2
Chapter 2 • Installation ............................................................ 2-1
Rear Panel Connectors ........................................................ 2-2
Installation ................................................................................ 2-2
Application Example ............................................................ 2-4
Making an RCP Communication Cable ....................... 2-4
RCP 2000 to ISS 108/408, SGS 408 RS-232 link ..................... 2-5
RCP 2000 to ISS 108/408 Ethernet link ................................. 2-5
Chapter 3 • Operation ................................................................ 3-1
Top Panel Controls ................................................................. 3-2
Using the Picture Controls ................................................ 3-5
Adjusting color and tint ........................................................ 3-5
Adjusting contrast and brightness ....................................... 3-5
Sizing an image ..................................................................... 3-5
Centering an image ............................................................... 3-5
Detail adjustments ................................................................. 3-6
Applying and Changing a Switching Effect ............. 3-6
Cuts ......................................................................................... 3-6
Dissolves ................................................................................. 3-7
Changing the duration of a dissolve .............................. 3-7
Wipes (SGS only) .................................................................... 3-7
Standard wipe .................................................................. 3-7
Curtain wipe ..................................................................... 3-8
Plus wipe .......................................................................... 3-8
Square wipe ..................................................................... 3-9
Title ................................................................................... 3-9
Selecting a wipe and a wipe duration ............................ 3-9
Implementing an effect ...................................................... 3-10
Implementing a title ............................................................ 3-11
Resetting the Unit ............................................................... 3-11
Chapter 4 • Remote Control .................................................. 4-1
Manual IP Setup ..................................................................... 4-2
Changing the IP addresses .................................................... 4-2
Network IP Setup and Control ........................................ 4-4
Contacting the RCP unit ........................................................ 4-4
Table of Contents
QS-2
Six sizes of male-to-male RS-232 cables are provided with the
RCP 2000, any of which can be used to connect the SGA or
ISS switcher’s RS-232 port to the RCP 2000’s To Switcher
(RS-232) port. If you require a length of cable other than what
is provided, you can make your own communication cable (see
Making an RCP Communication Cable in chapter 2).
Additionally, you can connect the RCP 2000 to the ISS via
Ethernet using a network cable (not provided).
Step 4
Continue the procedure for installing the ISS 108/408 or SGS 408.
Step 5
Attach power cords and plug the ISS or SGS seamless switcher, the
input devices, and the output devices into a grounded AC source.
Attach the power cord to the RCP 2000.
Step 6
Select an input using the RCP 2000 top panel (Program input)
buttons. The image should now appear.
Step 7
If the image does not appear, do the following:
• Ensure that all devices are plugged in and receiving power.
• Check the cabling and make adjustments as needed.
• Select a different input to check for an image.