Installation, cont’d, Rear panel connectors, Installation – Extron Electronics RCP 2000 User Manual
Page 7
RCP 2000 • Installation
Installation, cont’d
RCP 2000 • Installation
Rear Panel Connectors
ETHERNET
LINK
120-240VAC 50/60 Hz
1.2A MAX.
TO SWITCHER
ACT
RS-232
RESET
1
4
3
2
5
Figure 2-1 — RCP 2000 rear panel
1
AC power connector —
Plug a standard IEC power cord from a
100 to 240 VAC, 50/60 Hz power source into this connector.
2
To Switcher port —
This 9-pin female D connector provides for
two-way RS-232 serial communications with the SGS or ISS
switcher. Connect an RS-232 cable from this port to the
switcher’s RS-232 port.
3
RS-232 port —
This 9-pin female D connector provides for two-
way RS-232 serial communication with the computer to control
the RCP 2000.
4
RJ-45 connector —
Connect the RCP 2000 to an ISS 108/408
over an Ethernet LAN using this female RJ-45 connector.
5
Reset button —
Use an Extron Tweeker or a small screwdriver
to press this recessed button to reset the RCP 2000 unit. See
Resetting the Unit in chapter 3 for additional information.
Installation
To install and set up the RCP 2000, follow these steps:
1
Turn all of the equipment off. Make sure that the
ISS 108/408 or SGS 408 and all attached devices are
turned off and, if applicable, disconnected from the power
source.
2
Set the RCP 2000 on a table or other flat surface.
Installation
2-2
3
SGS Switcher:
Attach
one of the RS-232 cables provided with the RCP
2000 between the RS-232 Remote port on the rear panel of
the SGS and the To Switcher port on the rear panel of the
RCP 2000.
ISS Switcher:
Attach
one of the RS-232 cables provided with the RCP
2000 between the RS-232 port on the rear panel of the ISS
and the To Switcher port on the rear panel of the RCP
2000; or attach a network cable between the ISS and RCP
2000 rear panel Ethernet ports.
4
Continue the procedure for installing the ISS 108/408 or
SGS 408.
5
Attach power cords and plug the ISS/SGS seamless
switcher, the input devices, and the output devices into a
grounded AC source.
6
Attach the power cord to the RCP 2000.
7
Select an input using the RCP 2000 top panel Program
input buttons. The image should now appear.
8
If the image does not appear, do the following:
•
Ensure that all devices are plugged in and receiving
power.
•
Check the cabling and make adjustments as needed.
•
Select a different input to check for an image.
2-3