Extron Electronics RGB 560 AKM User Guide - Manual (Page 10)

Installation and Operation, cont’d
RGB 500 AKM and RGB 560 AKM Installation and Operation 2-2
Installation and Operation
Front Panel Features
Figure 2 — RGB 500 AKM front panel
Figure 3 — RGB 560 AKM front panel
1 Signal output and interface power cables — Five BNC female connectors
for video output: red, green, blue, horizontal sync (black), and vertical sync
(yellow); one 5-pole 3.5mm captive screw connector for audio output (see
“Audio output connector” on page 2-6); and one 3-pole 3.5mm captive screw
connector for 12–24V AC or DC power (see “Power connector” on page 2-7).
2 Power indicator LED — The interface has a built-in autopower feature.
When power is applied but no signal is present, the LED lights amber. When
a signal is present at the video/sync input, the interface powers on, and the
LED lights green.
3 Min/Max LED — This LED lights briefly when the horizontal shift knob is
turned to its minimum or maximum adjustment limit.
4 Horizontal shift knob — Use this knob to adjust the horizontal position of
the display image left or right to center it each time a new computer is
attached to the interface.
The horizontal shift control has no mechanical limits to rotation. When the
minimum or maximum limit of the control is reached, the Min/Max LED
lights briefly.
DDSP will disable horizontal shift control.
RGB 560 AKM with ADSP TM
BUFFERED
LOCAL OUT MIN/MAX
H. SHIFT
AUDIO
ID PIN 4 ID PIN 11
INPUT
1
2
4
6 3 7 9
10 11
RGB 500 AKM with ADSP TM
AUDIO INPUT
MIN/MAX
H. SHIFT
HIGH Z
1
2 4 7 3 5 6
8