Extron Electronics RGB 560 AKM User Guide - Manual (Page 15)

2-7 RGB 500 AKM and RGB 560 AKM Installation and Operation
Connect the sleeve to ground (GND). Connecting the sleeve to a
negative (-) terminal will damage the audio output circuits.
Figure 5 — Wiring for audio output
Power connector
Attach the 3-pole, 3.5 mm captive screw power connector to a 12 to 24VDC or 12
to 24VAC, .5A (minimum), external power supply, such as Extron’s #70-055-01.
The center pole contains no conductor. Connect conductors to the outer two
poles only.
Polarity is not important: the positive or negative wire can be connected to
either of the outer poles.
Signal cables
Attach the BNC connectors to the video display device.
• For RGsB, attach the red, green/sync, and blue cables.
• For RGBS, attach the red, green, blue, and black (sync) cables.
• For RGBHV, attach the red, green, blue, black (horizontal sync), and yellow
(vertical sync) cables.
Connecting input cables
Connect the input cables temporarily for testing. (Figure 6, on the next page, shows
a typical application.) Then, disconnect them so any switch or jumper adjustments
can be made. The interface can then be installed in the Ackermann floor tank.
Input cables can be reconnected after the interface is installed.
Use only Extron cables. Extron does not guarantee the performance of the
interface if a low quality cable is used for the input.
Connect the computer video and audio input cables and (for RGB 560 AKM) the
local monitor output cable.
Pre-installation testing/troubleshooting
Before completing the installation, test the system to make sure that the
connections and interface settings are correct.
1. Turn on the input device(s) (computer) and output device(s) (projector and/or
monitor). The image should now appear on the screen.
2. If the image is not displayed at all, double-check cable connections, and
ensure that all devices have power and are turned on. For the RGB 500 AKM
interface, try changing the video termination toggle switch setting. For the
RGB 560 AKM interface, if no local monitor is present, change the ID bit
termination via the front panel DIP switches, then reboot the computer.
Unbalanced Output
Tip
See Warning
Sleeve (GND)
Tip
See Warning
Balanced Output
Tip
Ring
Sleeve (GND)
Tip
Ring