Extron Electronics TP T Series Transmitters User Guide - Manual (Page 13)

2-3 TP T Series Transmitters • Installation and Operation
PRELIMINAR
Y
Configuring video jumpers for component, S-video, and
composite video
The TP T Series transmitters are configured at the factory for RGB video. To
transmit component video (bi-level sync only), S-video, or composite video, you
must place the video jumpers on the transmitter’s internal main board as follows:
1 . Remove the two screws on each side of the unit and one screw on top.
2 . TP T BNC DA4 only: Using an Extron BNC extraction tool (part #100-096-01)
or a 14 mm deep well socket wrench with thin walls, remove the five hex nuts
securing the BNC connectors to the rear panel. (See the illustration below.)
Slide the cover forward until the cover clears the BNC connectors.
3 . Slide the cover back until it clears the rear panel connectors, then lift it off.
TP T BNC DA4
Remove 5 BNC hex nuts.
Component,
S-video,
Composite
U31
J12
J11
J1
J2
1
1
1
1
Component,
S-video,
Composite
1
1
1
1
RGB
1
1
1
1
1
1
1
1
RGB
TP T 15HD A
Remove 6
screws.
TP
T 15HD
A
H-SHIF
T
BUFFERED
COMPUTER
INPU T
AUDI O
ID PIN
4
ID PIN 11
LOCAL MO
NITO R
TP T BNC DA4 TP T 15HD A and TP T 15HD AV
1 2 3 1 2 3
1 2 3 1 2 3
Pins
Pins
Slide cover back slightly
and lift straight up.
Configuring video jumpers
4 . Locate the appropriate jumpers on the circuit board:
For TP T 15HD A and TP T 15HD AV: J1 and J2
For TP T BNC DA4: J11 and J12
5 . Place the jumpers on the pins as follows:
• For RGB video, place the jumper so that it connects pin 2 to pin 3 at both
jumper locations.
• For any other video format, place the jumper so that it connects pin 1 to
pin 2 at both jumper locations.
6 . Replace the cover and reinstall the screws.