Extron Electronics TP T Series Transmitters User Guide - Manual (Page 21)

2-11 TP T Series Transmitters • Installation and Operation
PRELIMINAR
Y
f
Input BNC connectors — Connect the desired video input device to these
BNC connectors, which accept RGBHV, RGBS, RGsB, component video,
S-video, and composite video. Transmission of component video, S-video,
or composite video requires that internal jumpers be reconfigured. See
“ Configuring video jumpers for component, S-video, and composite video ”,
earlier in this chapter.
N Input only sync signals (no video signals) on the H/V and V BNC
connectors.
• For RGBHV video, use the R, G, B, H/HV, and V BNC connectors.
R G B H/HV V
• For RGBS video, use the R, G, B, and H/HV BNC connectors.
R G B H/HV V
• For RGsB or component video, use the R (R-Y), G (Y), and B (B-Y) BNC
connectors.
R G B H/HV V
• For S-video, use the R (C-chroma) and G (Y-luma) BNC connectors.
R G B H/HV V
• For composite video, use the G BNC connector.
R G B H/HV V
For three separate genlocked composite video signals, connect one wire
each to the R, G, and B BNC connectors.
R
-or- -or-
G B H/HV V
g
Computer video transmission connectors — Connect a TP cable from any of
these female RJ-45 output connectors to an Extron TP receiver.
N All video signals that are input on the computer input connector,
regardless of format, and audio signals that are input on a 3.5 mm jack,
are transmitted on these connectors.
C Do not connect this device to a computer data or
telecommunications network.
N RJ-45 termination must comply with the TIA/EIA T 568A wiring
standards for all connections.
h
Composite video transmission connector — Connect a TP cable from this
female RJ-45 connector to an Extron TP composite video receiver.
N Only composite video signals with audio ( d and e in the illustration
on page 2-9 ) are transmitted on this connector.