IPX DDK-1500D - Manual (Page 15)

15
9. If the message "UPDATE NG RESET PLEASE" appears rather than "UPDATE OK RESET
PLEASE", please write down the error messages shown on the screen and inform your
technical support, while ignoring the following steps.
10. Power off the IPCAM when this update process is finished, then remove the SD card from the
IPCAM.
11. Reconnect the Ethernet cable to the RJ-45 port if necessary.
12. Power ON the IPCAM and it will work normally if the entire update procedure goes correctly.
13. Verify the version of the system software.
WARNING :
1. Don’t use FAT32 or NTFS or other file formats in step 1.
2. Steps 1 to 3 have to be done on a PC.
3. Make sure the file of UPDATE.BIN is a correct one in step 3, or the IPCAM will not work
normally after being updated.
4. If the power of the IPCAM is suddenly lost in step 8, please remove the SD card first and
turn on the IPCAM next to test its operation. If the IPCAM remains working normally,
please go back to step 4; otherwise, please inform your technical support.
5. In step 10, if the SD card is not removed and the IPCAM does not get online as well, the
updating process must be repeated again after rebooting the IPCAM.
6. Make sure that the SD card is inserted in a correct position in step 5, or the IPCAM will
suffer permanent physical damage.
7. If the message "CSUM ERROR" appears in step 8, it implies a problem in the file of
UPDATE.BIN.
8. Don’t interrupt the process while the unit is updating itself; proceed with an SD card
not including any system software of the unit, or else the unit will crash.