IPX DDK-1700BC - Manual (Page 15)

15
3.2 Network Settings Configuration
3.2.1 Enabling DHCP Function
The DDK-1700BC ’s default setting is DHCP ON. An IP address can be obtained automatically from
a DHCP server. This function will only work if the LAN has a DHCP server.
3.2.2 Setting an IP Address
You need to set an IP address for the unit if DHCP is not supported on the network. Otherwise,
please follow the instructions given below:
Note: The default static IP is 192.168.1.168.
Set the IP, MASK and GATEWAY settings to the following:.
IP:
192.168.1.X
MASK: 255.255.255.0
GATEWAY: 0.0.0.0
NOTE:
When a DDK-1700BC is connected to a WAN, you must acquire a unique, permanent
IP address and correctly configure the MASK and GATEWAY settings according to
your network architecture. If you have any questions regarding those settings,
please consult a qualified MIS professional or your ISP.
NOTE: When connecting to a network, each connected DDK-1700BC must be assigned a
unique IP address, which must be in the same class type as your network address.
IP addresses are written as four sets of numbers separated by periods; for example,
192.168.1.1 Therefore, if the connected network is identified as Class C, for example,
the first three sets of numbers of the DDK-1700BC IP address must be the same as
the network address. If the connected network is identified as Class B, the first two
sets of numbers of the DDK-1700BC IP address must be the same as the network
address. If you have any questions regarding these settings, please consult a
qualified MIS professional or your ISP.