Magimix GELATO CHEF 2200 - Manual (Page 6)

DO NOT SWITCH ON THE BUTTON ON THE MAIN BODY OF THE MACHINE UNTIL
YOU HAVE READ ALL THESE INSTRUCTIONS.
Always use your Ice Cream Machine on a firm, flat surface near a convenient power outlet.
Place the machine so that the ventilation slots on either side are unobstructed.
Check that the voltage shown on the rating plate corresponds to the voltage of the mains.
Connect the plug to an electrical socket.
MAKING ICE CREAM IS EASY!
1. Connect the plug to an electrical socket
2. Turn the freezing switch on (B) for at least 5 minutes before pouring the ingredients in.
3. Place the paddle into the bowl.
4. Lower the lid and motor unit (D) onto the bowl.
5. Switch the paddle motor on (E).
6. Pour the mixture in.
In 20/40 minutes you will taste the best ice cream, frozen yoghurt or sorbet.
OPERATING WITH THE FIXED BOWL
Press the button (B) situated on the body of the machine (fig. 1) – this will switch on the
compressor. The yellow indictor light will come on. Allow the compressor to run for ot least
5 minutes to start cooling the bowl before pouring in the mixture.
Place the paddle into the fixed bowl; make sure you use the correct paddle – the larger with
a bump on the bottom is to be used in the fixed bowl. (Fig. 2) The flat based paddle is used
for the removable bowl.
Fit the motor-lid assembly as follows:
• Allow the clear lid to slide until the “Keyhole” part of the clear lid is over the hole in
which the spindle fits (fig. 3).
• Push the spindle into the hole (fig. 4).
• Slide the clear lid back into position, until a click is heard, this means that it is properly
slotted in. Ensure that the non-keyhole part of the lid fits between the top and bottom
collars of the spindle (fig. 5).
Lower the lid and motor unit onto the bowl whilst inserting the spindle into the top of the
paddle.
Turn the motor and clear lid in order to fit the tabs on the locking ring (F) into the holes
on the motor (Fig. 6).
Connect the cord of the paddle motor (C) to the socket on the machine body and switch on
to start operating the paddle.
Warning: ensure the paddle motor is fully locked otherwise it will not be possible to switch
it on. Connect the cord of the paddle motor (C) to the socket on the machine body and
switch on to start operating the paddle (fig. 7).
Next, pour in the previously prepared chilled mixture.
Depending on the quantity of ingredients and recipe used, you will have a delicious fresh ice
cream in 20/40 minutes.
4