Magimix GELATO CHEF 2200 - Manual (Page 7)

IMPORTANT: Never turn off the freezing switch (B) when the machine is working. In case
you accidentally switch it off or the power fails, wait at least 10 minutes before turning it on
again. The compressor is fitted with a safety device to prevent any possible damage to the
motor unit. Should you restart the machine immediately after it has been switched off, the
compressor will not freeze although the compressor will sound as if it is on.
When the ice cream has reached a good consistency, before you switch off the paddle motor,
the paddle may change its direction of movement.
This in no way damages the motor or the paddle, but it is nonetheless a good idea to
immediately turn the motor off as soon as this occurs.
If a firmer consistency of ice cream is desired, leave the freezing switch (B) on for a further
5-10 minutes.
Warning: remember to switch the freezing switch (B) motor off; otherwise your ice cream
will harden too much!
Ensure you have switched the paddle motor (E) off, then remove the paddle motor and
transparent lid turning anti-clockwise and unplug the appliance.
Spoon out the ice cream using the enclosed plastic spoon or use a wooden spoon, so as not
to damage the sides and bottom of the bowl.
Then remove the paddle – scrape it and spoon the remaining ice cream out from the bowl.
After removing the ice cream, wait a few minutes until the bowl is no longer too cold to
touch, then use a damp cloth or paper towel to remove any residues of ice cream before
washing it thoroughly.
OPERATING WITH THE REMOVABLE BOWL
The removable bowl allows you to prepare different flavours in a short time.
To use the removable bowl, proceed as follows:
Pour 25 ml of alcohol or any liquor into the fixed bowl. As an alternative to alcohol, you can
use a solution of salt and water (20 ml of Water – 5 g of salt). However, should you use salt
and water it is important to thoroughly clean both bowls after use to remove any particles
of salt, particularly on the removable bowl to avoid corrosion.
Simply fit the removable bowl inside the fixed bowl (fig. 9). This ensures optimum
transmission of the low temperature between the fixed and the removable bowl ensuring
perfect ice cream.
Important: there are two slots where the handle of the removable bowl should be located. If
the removable bowl is not in the correct position the paddle motor can not be fitted.
Switch on the freezing switch (B), insert the paddle for the removable bowl and lower the
lid and motor unit onto the bowl inserting the spindle into the top of the paddle. Connect
the cord of the paddle motor (C) to the socket on the machine body and switch on to start
operating the paddle.
Pour the chilled mixture in.
When the ice cream is ready, remember to switch the freezing switch off, otherwise your ice
cream will harden too much. Ensure you have switched the paddle motor off.
Then remove the paddle motor and transparent lid turning anti-clockwise and unplug the
appliance.
Once you have removed the ice cream, thoroughly clean the removable bowl and
importantly the fixed bowl of water and salt or alcohol.
If the removable bowl turns round in the fixed bowl either the wrong paddle has been used or
too much liquid ( alcohol or salt and water solution ) has been used between the two bowls.
5