Andrew James AJ000079 90 Day Pet Feeder - Manual (Page 6)

6
General operation
Setting the Current Time
1.
All digits should now be flashing.
2. Press the CLOCK key to set the HOUR.
3. Press the TIMER key to set the MINUTE.
4. Press the SET key once to confirm the time, now the display will show
either 12 or 24 to indicate the display mode.
5. Press the CLOCK key to change between 12 or 24-hour display mode.
6. Press the START key to CONFIRM the clock setup.
7. (1 :07) will be flashing and you must now set the feeding times.
Setting the Feed Time and Number of Feeds per Day
1.
(1 07) should now be flashing. Digit-1 is the feeding number (times per
day), Digits 3 & 4 are the feeding time (in hours).
2. The display shows the 1st feeding time (1 07) this means the 1st feeding
will be at 7am.
3. With (1 07) flashing, press and hold (for 2 seconds) the SET key until Digit 3
& 4 start flashing (07).
4. Press the TIMER key to set the desired hour for feeding.
5. Press the SET key to confirm your setting and proceed to the 2nd feeding
time.
6. Repeat step 4 to set the desired hour for the SECOND feeding time.
7. At this point if you want to only feed 2 times per day. Press the START key
and you’re finished.
8. If you wish to feed a 3rd or 4th time each day, do not press the START key
and repeat from step 4.
Tip: If you pressed the SET key a 3
rd
time, but you did not want to feed 3 times
per day, just press the TIMER key and then press and hold the SET key (for 2
seconds) to start over, remember not to press the SET key after the second
feeding, press the START key to end your number of feedings per day.